Changing AT command Target - nrf9160

[Hkhan7861]

Good day

I have a lwm2m client running on a custom nrf9160 board.  I would like to run everything network related to network on a separate chip.  Assuming that the two chips use the same AT commands, would it be possible to easily configure the change?  If so please provide some guidance on how I can do this

Kind regards,

Hassan

[Amanda Hsieh]

Hi,

Since there is no AT command set available for the NET subsystem, the communication must be developed in your application. You can have a look at the Nordic Dev Academy for how to implement uart in your application. 

Regards,
Amanda H.