Hello I have a board that I am trying to profile with the power profiler kit 2 and the readings seem very wild. I have a device that I know the base configuration with the sensors on is about 100uA measured with a fluke multimeter. The issue I am seeing is that I am getting current levels between 2uA and 30mA with the BLE on and I can not get a steady state current. This is the case with 2 separate PPK2 win Ampere Meter mode and Source Mode. In source mode the current spikes show over 100mA. it seems that the auto sensing is a bit haywire. I am using the latest release of the power profiler sw.
From my measurements I should not be going below 20uA even with the sensors off and I am seeing sub 1uA for several mS even with a rate of 100k samples per second.
