NRF24L01+ working irregulary

[Fred Lamer]

Hi everyone,

I bought two NRF24L01+ off ebay a couple of week ago and started to work on them this week. I seem to have problem with establishing a reliable communication between both devices. I enabled Shockburst by setting register EN_AA all to "1" and register EN_RXADDR all to "1". I should then have auto-acknowledgement on the TX device. Both device work with the IRQ pin with external interrupt on my two MCU (ATMEGA8) and interrupt are masked with the STATUS register to show what interrupt is trigerred by the NRF. I seem to have a bad communication, but the packet still cross from the TX to the RX irregularly. I checked the value of the received packet and it is the same as the one sent., but no acknowledge received in the TX device...

Any fast thoughts on why it would do this?

Thanks, Fred

[Fred Lamer]

I use the same address as in the apprendix A int the product datasheet. TX5 device: TX_ADDR = 0xB3B4B5B605 TX5 device: RX_ADDR_P0 = 0xB3B4B5B605 RX device: RX_ADDR_P5 = 0xB3B4B5B605 As for the module, so I don't have the link anymore.

For the range, it was tested a couple of inch apart, let's say about 6 inch. I read on the internet that the problem could come from a common ground so i alimented both module on separated power supply and putted a capacitor between VCC and GND, but I am still having the same problem...