nRF52811 project setup

[sumit-adep]

Dear community,

I have a custom PCB based on nRF52811.

Earlier i worked on nRF52840-DK successfully with less head-ache.

How can we configure any basic project for this nRF52811 Soc.

and
to flash it i have no board JTAG facility can i use nRF52840-DK for this purpose.

I am using Segger Embedded Studio V5.42a.

Thanks in advance.

[Edvin]

Hello,

So I assume that you are using the nRF5 SDK, since you mention Segger Embedded Studio. 

You can use the nRF52840DK, and build for the pca10056e, which will emulate nRF52811 behavior, as described here:

https://docs.nordicsemi.com/bundle/sdk_nrf5_v17.1.0/page/nrf52811_user_guide.html

When you get so far that you have a custom board with the nRF52811 on it, you can remove the preprocessor definition: "DEVELOP_IN_NRF52840", and it will be built to actually run on the nRF52811 instead of being emulated on the nRF52840.

Is that what you are looking for? Or did I misunderstand?

Best regards,

Edvin

[sumit-adep]

thanks edwin, 
It helped me.