Hello,
I am using the following device and development kit:
- Device: NORA-B106-00B (nRF5340)
- nRF Connect SDK: 2.0.2
When an interrupt is configured on the GPIO pin as shown below, the current consumption during sleep increases by 30 to 90 μA.
gpio_pin_configure_dt(&ms_intrtc, GPIO_INPUT); gpio_pin_interrupt_configure_dt(&ms_intrtc,GPIO_INT_EDGE_TO_ACTIVE);
When no interrupt is configured, the current draw in sleep is around 5 μA. Is it expected for the current draw to increase this much when an interrupt is configured?
Best regards,