Unable to run the example Bluetooth Periodic Advertising with Response on nRF5340 board using NCS 2.7.0

[Jagadeep Ram]

Hi Team,

I have nRF5340 DK board and I want to test the Bluetooth Periodic Advertising with Response and Bluetooth Periodic Advertising with Responses Synchronization examples.

But I see from the "sample.yml" files that it is only supported for nRF52840 board. How can I make these example to run on nRF5340 DK board.

I see that nRF5340 chip supports BLE 5.4 and these examples are also introduced from the same BLE version.

Examples:

v2.7.0\zephyr\samples\bluetooth\periodic_sync_rsp

v2.7.0\zephyr\samples\bluetooth\periodic_adv_rsp

It is important for our project to experiment these features on the nRF5340 chip. Please let me know how can I get them to work on our chip?

[Amanda Hsieh]

Hi, 

Check out this post. 

Regards,
Amanda H.

[Jagadeep Ram]

Thank you. It worked for periodic_adv_rsp example.

Could you also please make similar changes for periodic_sync_rsp and provide me a ZIP file?

[Amanda Hsieh]

Hi, 

Please try to duplicate sysbuild.conf and sysbuild/ipc_radio.conf to periodic_sync_rsp sample.

-Amanda H. 

[Jagadeep Ram]

Hi Amanda,

I tried having the following configuration in ipc_radio.conf file.

CONFIG_BT_EXT_ADV=y

CONFIG_BT_PER_ADV=y

CONFIG_BT_PER_ADV_SYNC_TRANSFER_SENDER=y

CONFIG_BT_PER_ADV_RSP=y

I have received the following error:

PAST subscribe failed (err -134)\n

Then I have replaced the following configurations:

CONFIG_BT_EXT_ADV=y

CONFIG_BT_PER_ADV=y

CONFIG_BT_PER_ADV_SYNC_TRANSFER_SENDER=y

CONFIG_BT_PER_ADV_SYNC_TRANSFER_RECEIVER=y

CONFIG_BT_PER_ADV_RSP=y

CONFIG_BT_PER_ADV_SYNC_RSP=y

CONFIG_BT_PER_ADV_SYNC=y

Now I pass the PAST subscribe error but failed at advertisements:

Advertising failed to start (err -13)

Could you please help me?

[Amanda Hsieh]

Check out this post. If it cannot help, please create a new support case. I will be out of the office for one week and will not reply to the case.