nRF9161 DK SPI Flash example

[nrao32]

I'm looking for a beginner's guide to setting up external flash on the nRF9161 DK. I saw nRF Cloud Multi-service as an example, but its docs did not explain what was needed hardware-wise to set up the external flash memory (I found this). Basically, I have a spare Adafruit SPI Flash SD Card XTSD 4GB, and I'm looking to connect it to the DK if possible. I assume I need to modify the board overlay but I'm not sure where to go from here. Where are the pins for gd25wb256 in the sample defined? 

[Hakon]

Hello,

(I found this)

that one is for nrf9160 dk. Nrf9161 uses a different flash chip. There are a lot of samples that show how to setup this, including asset tracker v2. I can try to help you setup this tomorrow.

[nrao32]

Thank you, Hakon, I look forward to more information on this.

[Hakon]

I'm in the process of setting up a sample. I will try to finish this by the end of  the week.