NRF7002 with non-Nordic MCU

[Lakshmi priya]

Hi,

We are interfacing WM02C (nRF7002) with LPC55S69JBD100E as the host controller.

1. Could you say how to select the 2.4 GHz and 5 GHz antenna selection by hardware/software?

2. Can the pins SW-CTRL0, SW-CTRL1, BT-CoEx-Status0, BT-CoEx-REQ, and BT-CoEx-Grant be left floating, pulled high, or pulled low when using the module exclusively for Wi-Fi with a host MCU—LPC55S69JBD100E?

3. Are filtering capacitors required on the input/supply pins? If so, could you recommend appropriate capacitor values?

[Elfving]

Hi,

I see that you have a very similar case already open in which you've asked those very questions before. I think it would be best if you could distinguish this case from the one you already have open. If not I think it would be best if I closed this case.

Regards,

Elfving

[John k]

Heyy , I am working on stm32 using nrf7002 for wifi shell can anyone tell me how to I am working on wifi with a stm32 board using the nrf7002 wifi module in zephyr.
Requirement is that : wifi shell work on stm32

I connect nrf7002 with a nucleo board using spi communication . But when I am going to write configuration related wifi and nrf in prj file it is not accepting means it shows error 

[Elfving]

Hi Abishek,

As this is a bit off topic, could you create a new DevZone ticket for this?

Regards,

Elfving