MESH CHAT

[jermi]

Hi nordic:

    I use two NRF52DKs and download MESH CHAT separately, hoping to achieve communication between the two NRF52DKs:

   SOFT VER: NCS2.8

  The specific process is as follows: 

  NRF MESH Network Add Node, select mesh chat:

Elements Disp No elements were found；

Where did I not set it correctly？

 best regards

jermi

[Edvin]

Hello Jermi,

Did you see any warnings when you built the sample? Does the UART log from the nRF say anything when you start the application?

I don't think it should matter, but could you try to add an App Key in the last screenshot. The third button from the bottom. 

I will test this tomorrow morning when I get in the office. 

Best regards,

Edvin

[jermi]

Hello Edvin:

     I Add An Key in the last screenshot. The third button from the bottom,

  Sent command From UART Disp:

How can I communicate on two Demo boards？

Best Regards

Jermi

[Edvin]

Try clicking the "Get composition data", and see if it comes up. This is usually part of the provisioning process, but perhaps it failed. 

Best regards,

Edvin

[jermi]

Timeout error, how do I handle it？

[Edvin]

Make sure you are still connected to the network. What does it say under the "proxy" menu in the nRF Mesh app?

Best regards,

Edvin

[jermi]