nrf8001 reset

[Bob Louwe]

BobLouwe.logicdataHi devs,

I'm setting up my own .NET mircro framework stack for the Adafruit nRF8001 Break Out board. When write the Reset port I do get an interrupt on the Ready port, but when I start reading from the SPI I getting all 0xFF. When I send a Test command (0x02, 0x01, 0x02) and put the REQN low (or REQ high) I do get the interrupt on the Ready port, but reading from the SPI gives me all 0x00.

I assume my SPI is not configured correctly, but I've read the documentation and it seems to be correct.

Thanks.

EDIT:

Capture file

EDIT: Bob Louwe clock low.logicdata

[run_ar]

As far as I can see from your logic trace you get the device started event after re-asserting the reqn line. The data you get before that doesn't make much sense to me, but you should make sure the clk line is low prior to lowering REQN. Please try this and let me know how that goes.