Programming nRF54L15 prototypes using nRF54L15DK

[krog1]

In the past, we've been able to use the nRF52-DK to flash our boards, supplying power through the debug port by shorting SB32.

For our L15 prototypes, the nRF52-DK doesn't seem to work, so we're using the new nRF54L15DK. I can't find any instructions online (yet) on how to supply power through the debug port.

There are two solder bridges near the debug out port, and I'm guessing it's one of these. However, before I fire up the soldering iron, can someone let me know which (if either) I should be shorting?

Thanks!

[PaKa]

There are no such solderbridges on the nRF54L15 DK so power must be supplied some other way to your external target. You can tap one of the power rails on the DK but not supply it through the 10 pin cable.