Arduino Nano 33 BLE sense rev2 serial Monitor in zephyr envirnoment

[Ebi777]

Hi, after uploading a Zephyr project (like the "Hello World" example), I couldn't see the device in the serial monitor. i add the below commend in overlay file also but still nothing is happening i read some document says the uart stack is not enabled in the arduino board after uploading the sample code but after enabling that also same issue i am getting. 

Board: Arduino Nano 33 BLE sense Rev2 (which has nRF52840 microcontroller in it)
Platform : nrF connect sdk in vs code and zephyr environment both i tried

overlay file:

&usbd {

status = "okay";

cdc_acm_uart {

compatible = "zephyr,cdc-acm-uart";

label = "CDC_ACM";

};

};

Need to see the serial monitor in zephyr environment using Arduino Nano33 BLE sense rev 2 board.

[Edvin]

Hello Ebineser,

I am sorry, I am not familiar with this HW, so I don't know how it is supposed to work. It is not clear to me whether it is the UART or the USB peripheral that is connected to your serial port. I think you need to reach out to the producers of your board to ask how you are supposed to use it outside the arduino IDE.

Best regards,

Edvin