BLE measurements nRF54L15

[Hans Erik Gram]

Hi Nordic

I am curious how to test nRF54L15 BLE sensitivity and Blocking. 

I am currently using:

1) nRF Connect For Desktop" v5.1.0   

2) Direct Test Mode v2.4.0 

TX test work finde but I can't figure out, how to setup receiver test. in Direct Test Mode v2.4.0 GUI.  

The nRF54L15 need to be connected to our BLE test system via UART connection.  But I can't see, how it is setup in Direct Test Mode v2.4.0 GUI.

Best Regards 

Hans Erik 

[Jørgen Holmefjord]

Hi Hans Erik,

To setup a receiver test in the DTM app in nRF Connect for Desktop, you need to go to the "RECEIVER" tab:

From there, you can configure the channel, PHY, etc. and start the test.

Best regards,
Jørgen