This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Which tools I need to work with nRF24LU1+ and using as HID usb dongle?

I want to use the nRF24LU1+ for a project where it will be a HID usb dongle. But I dont get which tools I need to make it. The KIT DEVELOPMENT NRF24LU1+ work for it?

Thanks

Top Replies

jing over 9 years ago +1

You can check out Nordic's nRFReady Desktop reference design(s) which includes a sample HID USB dongle project that supports mouse/keyboard/remote functionalities. www.nordicsemi.com/.../nRFready-Desktop…
run_ar over 8 years ago in reply to jing +1

Yes, If I remember correctly you can program the dongle using the board with the SMA connector together with the red cable. Of course you also need a nRFgo Motherboard.
jing over 8 years ago in reply to jing +1

As what run_ar had mentioned, you can program it over the USB port. Blank lu1p ic from Nordic comes with a bootloader. nRFGo Studio (sw tool) shall be able to detect the dongle running the bootloader code…

Parents

0 jing over 9 years ago

You can check out Nordic's nRFReady Desktop reference design(s) which includes a sample HID USB dongle project that supports mouse/keyboard/remote functionalities.

www.nordicsemi.com/.../nRFready-Desktop or www.nordicsemi.com/.../nRFready-Desktop-2-Reference-Design

Project can be built using Keil's toolchain for 8051 mcu.

jing
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Alvaro Macias over 9 years ago in reply to jing

Hi Jing Thanks for the answer, but the HID USB dongle can be programming by USB port or I need other tool?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Alvaro Macias over 9 years ago in reply to jing

Hi Jing Thanks for the answer, but the HID USB dongle can be programming by USB port or I need other tool?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data