Hi,
I'm running the "samples/pmic/native/npm1300_one_button" PMIC sample w/ my nrf54l15k. I'm able to initialize the PMIC through I2C successfully using the sample default pins:
i2c21_default: i2c21_default {
group1 {
psels = <NRF_PSEL(TWIM_SDA, 1, 11)>,
<NRF_PSEL(TWIM_SCL, 1, 12)>;
};
};
i2c21_sleep: i2c21_sleep {
group1 {
psels = <NRF_PSEL(TWIM_SDA, 1, 11)>,
<NRF_PSEL(TWIM_SCL, 1, 12)>;
low-power-enable;
};
};
However, my custom board requires me to use I2c on pins 2,3 in port 0
i2c30_default: i2c30_default {
group1 {
psels = <NRF_PSEL(TWIM_SDA, 0, 2)>,
<NRF_PSEL(TWIM_SCL, 0, 3)>;
};
};
i2c30_sleep: i2c30_sleep {
group1 {
psels = <NRF_PSEL(TWIM_SDA, 0, 2)>,
<NRF_PSEL(TWIM_SCL, 0, 3)>;
low-power-enable;
};
};
I'm using the same configuration and overlays, I'm even disabling address conflicting peripherals. According to the datasheet I should use spi30 for gpio port 0
&spi30{
status = "disabled";
};
&uart30 {
status = "disabled";
};I'm unable to use this pins for TWI and configure the 1300PMIC correctly, what am I missing? this is the generated dts
1030.zephyr.dts
