nrf9160 with npm1300 fuel gauge

[dave]

Hi

I am using the nrf9160 with the npm1300 fuel gauge with ncs 2.7

For the function `nrf_fuel_gauge_process` there is a note for the vbus_present param `vbus_present True if vbus voltage is present, for devices that supports this.`

Does the nrf9160 support this? 

When we set this to true when vbus is present, the code crashes with a secure fault... so I am guessing it isn't supported and should be set to 0, but I wanted to check.

I'm not sure where I would look to see if it is supported on the 9160 or not.

[Michal]

Hello, where did you get the vbus present from?

In the nrf_fuel_gauge_process documentation for NCD 2.7.0 I don't see anything like that.

Best regards,

Michal

[dave]

We have an interrupt set up for the pmic to notify the nrf9160 when it is being charged, so we were setting the vbus present  based on that