We have found a nrf52833 DK (PCA101000) with id, 685888541 with 2024.4.
So, it might be used as previous project in our company.
Anyway, I tried to test with this DK board. but I found the fail of j-link connection via PC.
First of all, when I attached dk board to PC, device manager on PC shows device drivers shown as MSD Volume USB Device, J-link driver and JLink CDC UART Port.
So I guessed the DK board was normal. Even thought it looks normal, I found the failure on J-link connection on on-board JLink on nRF52833 DK board.
The error are as following:
D:\ProgramFiles\SEGGER\JLink_V794e>JLink.exe SEGGER J-Link Commander V7.94e (Compiled Jan 15 2024 15:20:36) DLL version V7.94e, compiled Jan 15 2024 15:18:46 Connecting to J-Link via USB...O.K. Firmware: J-Link OB-SAM3U128-V2-NordicSemi compiled Oct 30 2023 12:12:17 Hardware version: V1.00 J-Link uptime (since boot): 0d 00h 01m 36s S/N: 685888541 License(s): RDI, FlashBP, FlashDL, JFlash, GDB USB speed mode: High speed (480 MBit/s) VTref=3.300V Type "connect" to establish a target connection, '?' for help J-Link>connect Please specify device / core. <Default>: NRF52833_XXAA Type '?' for selection dialog Device> Please specify target interface: J) JTAG (Default) S) SWD T) cJTAG TIF>S Specify target interface speed [kHz]. <Default>: 4000 kHz Speed>10 Device "NRF52833_XXAA" selected. Connecting to target via SWD InitTarget() start InitTarget() end - Took 90.4ms Found SW-DP with ID 0x2BA01477 DPIDR: 0x2BA01477 CoreSight SoC-400 or earlier Scanning AP map to find all available APs AP[0]: Stopped AP scan as end of AP map has been reached Iterating through AP map to find AHB-AP to use Attach to CPU failed. Executing connect under reset. Failed to power up DAP Connect fallback: Reset via Reset pin & Connect. InitTarget() start InitTarget() end - Took 89.8ms Found SW-DP with ID 0x2BA01477 Failed to power up DAP Cannot connect to target. J-Link>
Please let me know how to solve this problem.
Thanks,
Jaehong Park
