JLink loading into a secured nRF54 device

[bios-bob]

i'm working "bare-metal" with the nRF54-DK, loading from the command-line by directly calling JLink....

often (but not always) i receive the following message from JLink:

clicking through this, my image loads just fine....

is there something i should do in my target firmware to "unsecure" the device???

at this stage, i'm in development and am constantly re-flashing my HW

[Emil Lenngren]

Make sure this line is called in your code at application start: github.com/.../system_nrf54l.c. It opens up the debugger.