ESB Telec and FCC Certification

[DX_HK]

I am developing a device that uses ESB.

Uses modules that are Telec and FCC certified with BLE profiles.
(module : MDBT50Q-512K)

I have a few questions.

Q1.
The TX power is configurable on the ESB, I don't know how that corresponds to the signal strength for certification.

How can I check the allowed TX power?

Q2.
Module certification:
FCC
15C 2402~2480MHz 0.0066W
Telec
FID 2402~2480MHz 5.9704mW/5.0816mW

Are these certification valid for ESB (2Mbps)?

[Elfving]

Hi,

Just to clarify:

How can I check the allowed TX power?

So you do know how to set it, but you wonder where you can check how high you can set it, for it to still follow the certification?

Regards,

Elfving

[DX_HK]

Yes, that's right.

I want to use the maximum TX power possible while still maintaining certification.

[Elfving]

Understood. My go-to ESB resource is unfortunately corrently sick. If it is okay with you, I'll get back to you on this once I can hear with him on this. If this case is more urgent however, let me know and I'll find this out some other way for you.

Regards,

Elfving

[DX_HK]

This question came up while I was preparing the FW for testing.
I hope to reach a conclusion by the end of this week.

So I'd like to check it as soon as possible.

[Elfving]

Hi again, and thank you for your patience on this,

Q1.
The TX power is configurable on the ESB, I don't know how that corresponds to the signal strength for certification.

How can I check the allowed TX power?

The requirements should be the same as for BLE:

FCC&US has a max of 20 dBm, Telec&Japan (along with the rest of the world) has 10dBm = 10 mW.

Are these certification valid for ESB (2Mbps)?

Could you expand a bit on this part? Where are you getting these?

Regards,

Elfving