Wakeup from sleep with GPIO

[Marco Russi]

Hi, I would like to put a nrf51822 device into system off mode and wake it up with a GPIO transition from high to low. I would like to measure the press time of the button after wake up but it seems that software doesn't run properly until the button is pressed. So, does the software run normally after the reset transition even if the button is still pressed? I hope it is clear. Thanks.

[RK]

Well the software doesn't run properly until the button is pressed because it's off. After you press the button and the chip resets then of course it will run normally, from the very start of your code. If you want to measure the press time of the button, then you'll have to detect at the start of your code if the button is currently pressed and start timing it, and you'll miss the time it takse for the system to reset itself.

[Marco Russi]

Hi, thanks for your reply. Of course the software doesn't run in system off mode. Anyway, the pin is configured to wake up the device at a low level. I use a timer for measuring the press time from the beginning of the software. Now, when I press the button (transition from high to low) it seems that the software doesn't run until the button is released (transition low to high). So, at the first button press nothing happens while at the second press I can measure a press successfully. So, does the software resets and runs after the first transition high to low (with level remaining at low level) or the software starts running at the next low to high transition? Thanks.