nRF54L15 matching antenna inverted f.remove matching network component

Currently nRF54L15 is being matched with LOW Q circuit and unipolar antenna. Because low Q circuit takes a lot of components and time when designing hardware. So I can remove the Matching component in the schematic diagram leaving only 3 components. And using nRF54L15 with inverted f antenna impedance matching with only 3 components is there any big problem?

Parents
  • Hi.

    I'm afraid you can not make any changes to the radio's matching network. Copying this directly from the reference design, both in regards to the schematic and the layout, is crucial when it comes to filtering of the harmonics.

    Best regards,
    Mathias

Reply
  • Hi.

    I'm afraid you can not make any changes to the radio's matching network. Copying this directly from the reference design, both in regards to the schematic and the layout, is crucial when it comes to filtering of the harmonics.

    Best regards,
    Mathias

Children
No Data