ppk2 Disconnects

[BYomtov]

I've been using the ppk2 power profiler with version 4.0.1 for over 2 years and it has worked very well in providing a power source and monitoring/ with reviewing the power profile trace. I just recently purchased an second ppk2 which has version 5.1.0. The new ppk2 keep disconnecting the power supply after about 48 hours of continuous operation. In comparison the older ppk2 with 4.0.1 continues to operate with no problem.  Please provide feedback as to the proper settings with the newer software revision so that it will not disconnect.

Thanks

Barr Yomtov

[Edvin]

Hello,

I will ask our PPK team if there are any significant changes that may cause this. I will try to replicate it as well, but it will take some time (for obvious reasons). 

Is your impression that it takes 48 hours accurately? If not, is it the same amount of time every time? Or does it vary around 48 hours?

Please note that we will be out on public Holiday in Norway from Thursday this week until Tuesday next week. Please expect some delay in our responses. I am sorry for the inconvenience.

Best regards,

Edvin