Hello,
I want to perform some antenna measurements and compare the rf performance of my custom PCB with an nrf9160 SiP with the nrf9160 dk.
To perform some antenna measurements, we want the modem to transmit continuously at a specific frequency. I am aware of the production test AT command (AT%XRFTEST). But even when I send the AT command to set it in continuous wave mode, I see on the spectrum analyzer that it is not transmitting continuously. Is there any other way to do this?
The AT command I am sending is as follows: AT%XRFTEST=1,1,8,8800,23,1,4,6,0,0,0,0,1
I am using modem firmware version v1.3.6 and nrf SDK v2.5.1.
Best regards,
Royce