BLE Scan for production Test

[SvenSi]

Hello,

we would like to test our product after production. So I would like to connect a PC to the unit via BT-LE. My Idea was to use the nRF52840-Dongle like the nRF Connect for Desktop is using it. 

I have seen that the Dongle is shown in the device-Manager as COM-Port ("USB CDC ACM"), but I did not find any informations on the commands that can be sent. Is there any documentation about this? 

I would like to make a scan with a specific address and connect to this device (is found) to read one GATT-Characteristic. 

[Priyanka]

Hi Sven,

When you connect the Dongle and are using it with the nRF Connect for Desktop app, there is a special connectivity firmware that is being run on the Dongle and this firmware uses the COM port to communicate with the app via a binary protocol. So there is no AT commands which are sent via a serial terminal.

-Priyanka

[SvenSi]

Hello Priyanka,

I understand, that it is a binary protocol. I think that´s no problem as soon as a documentation is available ;-)

But where can I find this documentation? Or can you lead me to the part of the source code that connects with the dongle? Is it included in the github repo?

I would like to use the Dongle "as is" with the firmware that is used by nRF Connect. So I can make manual test with this Software. And I would like to make only a few steps:

- Search fo a specific MAC-Adress
- Connect
- Read one Characteristic
- Disconnect.

I think this should be possible with the binary commands.