Hello, I have an issue regarding the current measurement of my nRF7002DK_nRF5340. I am trying to measure the current consumed during the transmission of a carrier on a Wi-Fi channel (with oscilloscope). I am using the example: Wi-Fi: Radio test (Multi domain).
However, by following the current measurement instructions https://docs.nordicsemi.com/bundle/ug_nrf7002_dk/page/UG/nrf7002_DK/hw_measure_oscilloscope.html
When I remove the jumper, the carrier disappears; the board stops transmitting. Which is obviously annoying, the initial goal is to know the consumption during transmission.
I followed the instructions correctly, placing a 10-ohm resistor on the footprint R91, and there is no USB power supply.
Did I miss something ?