Hi,
I am working on ncs 2.9.1 @ nRF54L15.
I followed this academy course to add a single channel saadc in simple mode:
/* STEP 5.1 - Connect ADC interrupt to nrfx interrupt handler */
IRQ_CONNECT(DT_IRQN(DT_NODELABEL(adc)), DT_IRQ(DT_NODELABEL(adc), priority), nrfx_isr, nrfx_saadc_irq_handler, 0);
/* STEP 5.2 - Initialize the nrfx_SAADC driver */
nrfx_err_t err = nrfx_saadc_init(DT_IRQ(DT_NODELABEL(adc), priority));
if (err != NRFX_SUCCESS) {
LOG_ERR("nrfx_saadc_mode_trigger error: %08x", err);
return -1;
}
/* STEP 5.3 - Configure the SAADC channel */
channel.channel_config.gain = NRF_SAADC_GAIN1_4;
err = nrfx_saadc_channels_config(&channel, 1);
if (err != NRFX_SUCCESS) {
LOG_ERR("nrfx_saadc_channels_config error: %08x", err);
return -1;
}
/* STEP 5.4 - Configure nrfx_SAADC driver in simple and blocking mode */
err = nrfx_saadc_simple_mode_set(nrfx_saadc_channels_configured_get(), NRF_SAADC_RESOLUTION_12BIT, NRF_SAADC_OVERSAMPLE_DISABLED, NULL);
if (err != NRFX_SUCCESS) {
LOG_ERR("nrfx_saadc_simple_mode_set error: %08x", err);
return -1;
}
/* STEP 5.5 - Set buffer where sample will be stored */
err = nrfx_saadc_buffer_set(&sample, 1);
if (err != NRFX_SUCCESS) {
LOG_ERR("nrfx_saadc_buffer_set error: %08x", err);
return -1;
}
err = nrfx_saadc_offset_calibrate(NULL);
if (err != NRFX_SUCCESS) {
LOG_ERR("nrfx_saadc_offset_calibrate error: %08x", err);
return rc;
}
/* Step 7.2 - Trigger the sampling */
err = nrfx_saadc_mode_trigger();
if (err != NRFX_SUCCESS) {
LOG_ERR("nrfx_saadc_mode_trigger error: %08x", err);
return rc;
}
/* STEP 7.3 - Calculate and print voltage */
int adc_voltage = ((900 * 4) * sample) / ((1<<12));
int battery_voltage = adc_voltage * 1220 / 220;
LOG_DBG("SAADC sample: %d Battery Voltage: %d mV", sample, battery_voltage);
ADC read works properly, but the current read from PPK2 raised from 30uA to 1.3mA when nrfx_saadc_mode_trigger been called.
How to disable saadc after sampling is triggered?
I tried call nrfx_saadc_abort but the current is still high
Regards,
Anthony
