High frequency PWM shifts phase when radio is active

[grow mane]

When setting up a 1Mhz square wave using NRF_PWM on the NRF52 or GPIOTE on the NRF51 while BLE is advertising, the PWM stops when the radio is active. The problem doesn't happen when the frequency is below 6khz. No PWM interrupt is enabled. Is this an unavoidable limitation with high PWM frequencies?

[grow mane]

Setting the old Rigol to "long memory" mode got the sample rate up to 20 Megsamples, which revealed there may still be a phase shift when the radio turns on, but it's small enough to be within spec. The spec probably isn't stable enough to drive a high precision LCR meter.

June 6 update:

It's a clock frequency shift that happens when the NRF switches between the 32khz & 16Mhz crystals. The 32khz is 1% faster. This can be reproduced by initializing a program with

SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_XTAL_20_PPM, NULL);

or

SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_SYNTH_250_PPM, NULL);

Toggling a GPIO & viewing the frequency on a frequency counter. Unfortunately, the nrf_drv_clock_hfclk_request doesn't do anything after advertising is enabled, the current usage is too high to have it always on, so a clock that jitters 1% is what you get if you want to use the radio.

[Ole Bauck]

how large is the phase shift?

[WestCoastDaz]

Your June 6th update initializes the SoftDevice with the LF RC clock. Have you tried using the 32kHz LF crystal?