High frequency PWM shifts phase when radio is active

[grow mane]

When setting up a 1Mhz square wave using NRF_PWM on the NRF52 or GPIOTE on the NRF51 while BLE is advertising, the PWM stops when the radio is active. The problem doesn't happen when the frequency is below 6khz. No PWM interrupt is enabled. Is this an unavoidable limitation with high PWM frequencies?

[TeleToby]

I'm also experiencing this on my nrf52. I can see the advertising events causing the artifacts in the pwm output.

1. Advertising interval = 125x 0.625 ms = 78 ms
2. Advertising interval = 250 x 0.625 ms = 156 ms

This might be caused by the BLE-event requesting a clock change from RC to XTAL.

sd_clock_hfclk_request() did the trick in my case.

[TeleToby]

I call the function before I do ble_advertising_start(). I just tested this to see if the artifact disappared in my pwm output (I'm playing a 38khz sine), and it did.

This was just for test purposes, so I never release the HFCLK after that.

Whether this a solution or just a workaround I'll let the Nordic folks answer :)

 uint32_t p_is_running = 0;
	sd_clock_hfclk_request();
	while(! p_is_running) {  							//wait for the hfclk to be available
		sd_clock_hfclk_is_running((&p_is_running));
	}

    err_code = ble_advertising_start(BLE_ADV_MODE_FAST);