NCS 3.0.2, NRF52832 DK board, use 'peripheral_power_profiling' to measure current cost, but 52832 DK board do not RUN when power on

[Max_Singsun]

As subject, NCS 3.0.2, I use demo 'peripheral_power_profiling' to test current on NRF52832 DK board, but the demo cound not run when power on, There is no log output, and there is no flashing light after pressing the button 1/2/3/4. So what happen? Does this Demo confirmed on NCS 3.0.2 ??

[Max_Singsun]

I use  vscode to flash originally, later use Programmer 4.6.2 to flash merge.hex, but result is same, NOT work at all! Can anyone tell me what it is?

[Einar Thorsrud]

Hi,

In order to be low power, logging is disabled by default. Set the three loggign reladed configurations in the end of prj.conf to y to see the logs.