Issue of Scanning failed to start for matter bridge

[Tom.Fu]

Hi Support Team

I tested matter bridge sample running on the nRF7002DK with peripheral_lbs sample running on the nRF54L15DK.

Application guide

Then I encountered problems like the following screenshot.

I just add the following Kconfig options to the project.

[Kazi Afroza Sultana]

By the way, in addition to my previous comment, what change you made on the config file? I can't open the screenshot. 

[Tom.Fu]

Hi Kazi

The peripheral_lbs sample was run with default configuration and it was run on the following nRF54L15DK. Smart phone can scan the LBS.

The matter bridge sample was run on the following nRF7002DK. I just add the following two Kconfig options to prj.conf.

CONFIG_BRIDGED_DEVICE_SIMULATED=n

CONFIG_BRIDGED_DEVICE_BT=y

The following is the build configration for matter bridge sample. Many thanks.

[Tom.Fu]

Hi Kazi

Could you help analyze this problem? Many thanks.

[Amanda Hsieh]

Hi, 

Kazi is out of the office, so I pick up this case. 

Please refer to the command in the Bridged device configuration:

 

The VS Code build configuration looks like this:

Regards,
Amanda H.

[Tom.Fu]

Hi Amanda

Many thanks.

I set the VS Code build configuration for the matter bridge sample as per your suggestions, but it still fails to run.

 

[Amanda Hsieh]

Try to delete the build folder and build the project again.