This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

ble sniffer issue

michaelp over 9 years ago

When I start the "ble-sniffer_win_1.0.1_1111_Sniffer.exe" program I get this screenshot: image description

The port was found correctly (COM4) but I see no devices found.

Am I missing something? Should I do something prior launching this application?

0 Javier over 9 years ago

Hi michaelp.

The problem is it says that "your firmware is outdated".

Try to program again your board (if you need help to install it, press "u" to open User Guide and see page 5/17) with the file "ble-sniffer_nRF51822_1.0.1_1111_Sniffer.hex" that is in the folder "Firmware" with nRFgo Studio (you don´t need to program softdevice to sniffer) and after launch "ble-sniffer_win_1.0.1_1111_Sniffer.exe".

If the problem persist, try to download again ble-sniffer_win_1.0.1.

Javier.
0 michaelp over 9 years ago

Hi, Using nRFgo Studio I get the following screenshot:

It doesn't detect my device although it is connected.
0 Javier over 9 years ago in reply to michaelp

Hi, when you have connected your board, some led is blinking or on?