Current consumption for SPI and UART

[Tom.Fu]

Hi Support Team 

It seems that there is no current consumption information for SPI and UART of nRF54L15 in data sheet. We want to know the current consumption when SPI and UART run at 2Mbps. Could you provide us the information for evaluation? Many thanks.

[Susheel Nuguru]

Hi Tom,

You seems to be right, we did not give any current consumption numbers for different datarates for UART and SPI but it should be easy to get those numbers using a PPK2 and DK if you already have a sample running those peripheral at that speed.

Run a minimal EasyDMA loop and record the delta from idle to get a realistic peripheral current for 2 Mbps UART and 2 MHz SPI on your hardware

[Tom.Fu]

Hi Susheel

Thank you. Is there any simple sample recommended for testing UART and SPI? I find that only the high speed UART can support 2Mbps.

[Susheel Nuguru]

Tom, 

Yes, only the high speed UARTE can support speeds higher than 1Mbps.

I can suggest you these two sample for testing high speed UART and SPI if you change the overlay files to suit the high speed instances, clock frequencies and pin numbers you are using.

// For UART try async sample
west build -b nrf54l15dk/nrf54l15/cpuapp zephyr/samples/drivers/uart/async_api -- -DOVERLAY_CONFIG=prj.conf

// SPI loopback test
west build -b nrf54l15dk/nrf54l15/cpuapp ntg/tests/drivers/spi/spi_loopback

[Tom.Fu]

Hi Susheel

I find that only the UARTE00 support high speed UART. I configure the nrf54l15dk_nrf54l15_cpuapp.overlay file of async_api like the following screenshot and it can build successfully. I check the zephyr.dts file the uart00 node has been configured successfully. But the nRF54L15 DK has no output. Could you help check is there anything else I need to do? Many thanks.

async_api.7z

[Tom.Fu]

Hi Susheel

Sorry for interruption. Due to a customer is waiting for the results I measure. Could you help analyze the issue of high speed UART configuration? I want to measure the current consumption of UART at 2Mbps on nRF54L15 DK. Thank you so much.

[Susheel Nuguru]

The pinctrl-0 and pinctrl-1 are using the definitions of pf pinctrl define for UART20? why is that, there seems to be some pin conflict in your declaration.
UArt00 instance should be assigned to P2 pins and  not P1 pins.