s130 2.0.0 ROM and RAM settings?

[gdou]

Hi,

I am using a 128KB-rom 16KB-ram nrf51822 and trying to run blinky from SDK 11 with softdevice.

If I load nrf51 S130 1.0.0 softdevice, and use the following in my gcc compiling setting: FLASH (rx) : ORIGIN = 0x1c000, LENGTH = 0x4000 RAM (rwx) : ORIGIN = 0x20002800, LENGTH = 0x1800 I was able to run blinky.

After I change to S130 2.0.0 softdevice, and use the following: FLASH (rx) : ORIGIN = 0x1b000, LENGTH = 0x5000 RAM (rwx) : ORIGIN = 0x20002800, LENGTH = 0x1800 blinky does not work any more. I assume the RAM setting is wrong? what should be the correct setting?

Also what is the correct ROM/RAM setting for S130 2.0.0-7.alpha? I can't get blinky to work with this SD either.

Thanks for any help!

[gdou]

Thanks Ole - I am using this: NRF51822-QFAB-R7, on a custom PCB board. And I was able to make blinky work with both S130 1.0.0 and S130 2.0.0 now. However my ble_app_beacon still does not work on either of them. I tried to use S130 2.0.0-7.alpha because in the SDK 11 ble_app_beacon example I see it loads this version of softdevice. Does ble_app_beacon work with the release version of SD (S130 2.0.0)?