Start with nrf52832

[Derek89]

Hi everyone,

I’ve just started my adventure with the nRF52xxx family and have already hit a wall. In my previous project, I successfully programmed an nRF52840 dongle, but since it was done via USB, it was quite straightforward. Now I’d like to move on to the nRF52832.

I purchased a module from AliExpress and can’t figure out how to program it. I’ve read that I need a DK board (I have the nRF52 DK) and that it must be connected to this small BLE module, but I’m not sure how to proceed.

NRF52832 module

I would be very grateful for any guidance on how to tackle this beast.

Thanks,

[Turbo J]

There is a chapter in the DK documentation how to connect an external target properly. 

And no, we have not the slightest idea where those signals are on your board. That will be your task to either find out or use a module with proper documentation...