Enabling both Serial Recovery & FOTA on same target

[Nick_RA]

nRF54L15 + NCS 3.02 + Toolchain 3.02

So I have followed Dev Acadamy exercises for Serial Recovery and BLE FOTA. In my project I now have MCUBOOT for Serial Recovery but I need also to add BLE FOTA.

[Note I cannot use UART DFU within my application, because the application uses UART.]

What considerations are needed to use both mechanisms on the same target? For example, using dual slot. As a quick test I tried setting SB_CONFIG_MCUBOOT_MODE_SINGLE_APP=n but it wouldn't even boot after flashing.

Thanks,

[Menon]

Hello,

I believe this should work, but I don’t have a sample that enables both. Could you please share the minimal sample you have tried? I can take a look at it or try to reproduce it on my side.

Kind regards,
Abhijith