there is the possibility to have the coexistens in the same HW of a ble device stack and a IEEE802.15.4 (openthread or zeegbee) stack?

[novello]

Is possible to use ble stack for the configuration and disgnostic of a device and that use ieee802154   to make a start network  for 1 to 8 devices , where i can find an examples that can help me ? I have 2 phase :

a)  configuration  /Diagnostic 

b) run time  with a fast  udp message to the 8 devices that are not so far ( 30-40 ) meter .

Best Regards

Novello G.

[Susheel Nuguru]

What you are asking is possible on Nordic devices, including nRF5340.

For your use case,you can use BLE + Thread (OpenThread) rather than BLE + Zigbee, because you need fast UDP messages at runtime. Thread is IP-based and supports UDP natively