nRF54L15 – System OFF and System ON IDLE Current Higher Than Datasheet Values on BL54L15u EVM

[Ben012]

I am evaluating the nRF54L15 for an power sensitive application and are measuring power consumption on the BL54L15u evaluation module.

However, my measured current values are significantly higher than the datasheet typical values for both:

• System OFF mode with GPIO/GRTC wakeup: Datasheet Current: 0.7µA,  Measured Current: 8.7 µA 

• System ON IDLE mode withGPIO/GRTC wakeup and 256 kB RAM retention, Datasheet Current: 1.5 µA , Measured Current: 34 µA

I would like guidance on how to configure the device and/or EVM to match the datasheet conditions.

[MJJ]

Hello Ben, I am closing this ticket since there is a duplicate one posted. If I am mistaken and the two tickets are not the same please reply here to re-open this ticket.