Hi
I have two nRF5340 DK boards.
I cannot remember what I last used them for, but I can no longer connect up to them.
In VSCode, when I usually connect to an nRF board via USB, the device is then listed under Connected Devices, but neither of these nRF5340DK boards appear.
The USB cable I am using is good - it detects other nRF devices. (I have also tried other cables, and other ports on the PC)
Both boards have the on/off switch to ON, the power source switch to USB.
When I connect to the IMCU USB port, nothing is detected (and Device Manager sees nothing).
However if I connect USB to the debug port, it obviously gets some power, because I can see the LEDs operating, from whatever the last application that was flashed in to the device.
There are no jumpers on either board.
Both boards labels are: PCA10095 - 2.0.2 - 2023.33.
Any suggestions of next steps?
Thanks
