Failure in ble_stack_init during startup

[SteveHx]

We are trying to bring up a new run of an existing PCB design. No changes in the area of the processor, but a different assembly house. The first call inside ble_stack_init, a call to nrf_sdh_enable_request(), fails and returns an error code of 8. No reference anywhere gives a usable explanation.

Strangely, if started by "copying" the hex file onto the Jlink "drive" (the nRF52832 DevKit), it succeeds.

What should we be looking for?

[Vidar Berg]

Hello,

It seems like the issue might be with how the firmware is programmed since it appears to work when you use drag&drop programming. How are you programming the device when it fails? Is the same error also returned after a reset? Note that the "SoftDevice enable" function may return NRF_ERROR_INVALID_STATE (8) if the debugger forces execution to start from the application start address instead of address 0x0. This prevents the softdevice's reset handler from running on startup.

Best regards,

Vidar

[SteveHx]

I was starting it from SES (Segger) just as I have on dozens of previous nRF52832 projects, and indeed successfully on previous runs of this board. So there's something different in the hardware, and I'm asking where to look. What sort of "invalid state" is likely?

[Vidar Berg]

The invalid state is returned either because the softdevice has already been enabled, or because the softdevice's reset handler was skipped during the boot sequence. It is a known issue when using Segger that selecting Build & Run starts execution directly from the application, effectively bypassing the softdevice.

Similar case: https://devzone.nordicsemi.com/f/nordic-q-a/118688/nrf_error_invalid_state-softdevice-already-running 

[SteveHx]

I had anticipated that it might already have been initialized, so added a preceding call to nrf_sdh_disable_request(), but that had no effect.

What is the preferred approach when using Segger's Build&Run?

[Vidar Berg]

Build&Run does not work because it ignores the debugger settings and starts execution directly from the app skipping softdevice (and bootloader if present). Please try Build&Debug instead and check if you still get the invalid state error.