nrf54l15 SB_CONFIG_BOOTLOADER_MCUBOOT=y makes main() gpio toggle stop.

[Austin (S.F.)]

As title.

  In nRF54L15 DK,  I set "SB_CONFIG_BOOTLOADER_MCUBOOT=y" in file "sysbuild.conf".

  It makes main function GPIO toggle stop.

  Do have any solution to prevent this problem?

result:

[Vidar Berg]

Hello,

Is the gap shown in your logic trace happening while the chip is starting up after a reset? The bootloader executes first at startup and is responsible for validating the application's signature before booting it. However, 10 us seems a little too short to complete this part of the boot sequence.

Best regards,

Vidar

[Austin (S.F.)]

Hi Vidar

      The situation has no reset occur. 

      Austin

[Vidar Berg]

Hi Austin,

Thanks for confirming. 10 us was too short anyway. What is likely happening is that your main loop is preempted by the system timer interrupt (GRTC IRQn). This can happen regardless if you have a bootloader present or not. To confirm this, you can try to mask the interrupts before entering the while loop.

#include <zephyr/kernel.h>

int main(void)
{
    ...
    (void) irq_lock();
    while(1) {
        ...
    }
    ...

Best regards,

Vidar

[Austin (S.F.)]

Hi Vidar

    I added "(void) irq_lock();" before while(1), it works.

    The gpio toggle continues.

    I will check when (void) irq_lock(); added,  DFU works or not.

    Austin

    

[Vidar Berg]

No, it is not a solution to keep the IRQs locked. It will prevent DFU and other tasks from being performed. Maybe you can say a bit more about what you are trying to achieve and what your requirements are.

[Austin (S.F.)]

Hi Vidar

   Thanks your reply so quickly.

    I am using Timer00 every 4us interrupt once. (Note Timer20 is not works 4us, but 6us is okay)

    Because that I need very stable Timing to do RF transceive.(2.4G Propritery)

-------------------------------------------------------------------------------------------------------------

   By the way, do you know how to reduce Timer interrupt cost?

   The Timer Interrupt just toggle GPIO. and it cost 1us.

   Even I removed GPIO toggle from Timer Interrupt, it still cost 800ns.

    Austin