Question Regarding BLE Test (DTM)

Our company has been testing nrf52840 devices BLE using DTM as documented by Nordic.  RFBOX for Tester -> Coax ->Attenuator -> Rf Box For DUT -> DUT

We send the bit patterns in different channels and we compute the packet error rate.

Well, our management is having issues testing the devices inside RF boxes. They are requesting us to test without the RF BOX.
Either in DTM mode without box or with production firmware without box.

My question is, are there documented guidelines or application notes regarding testing without the RFBOX for the DUT.?

Are there any recommendations or strong reasons why is this not a good idea. (not that the current test do catch BLE failures but not very often).

Parents
  • Hello,

    We have this whitepaper for setting up production test using DTM: https://nrfconnectdocs.nordicsemi.com/pdf/nan_34/nan_34.pdf  We don't have anything without the RFBox. 

    Are there any recommendations or strong reasons why is this not a good idea. (not that the current test do catch BLE failures but not very often).

    The boards are put in separate shield boxes to isolate them from ambient RF interference. The main reason why it is not recommended to remove the RFBox is  ambient RF interference — Without shielding, external 2.4 GHz signals (Wi-Fi, other BLE devices, etc.) will corrupt your RX test results, causing false failures or masking real failures by artificially inflating or deflating PER measurements. Also, removing the box and going radiated introduces path loss variability that is hard to control.

    Best Regards,

    Swathy

Reply
  • Hello,

    We have this whitepaper for setting up production test using DTM: https://nrfconnectdocs.nordicsemi.com/pdf/nan_34/nan_34.pdf  We don't have anything without the RFBox. 

    Are there any recommendations or strong reasons why is this not a good idea. (not that the current test do catch BLE failures but not very often).

    The boards are put in separate shield boxes to isolate them from ambient RF interference. The main reason why it is not recommended to remove the RFBox is  ambient RF interference — Without shielding, external 2.4 GHz signals (Wi-Fi, other BLE devices, etc.) will corrupt your RX test results, causing false failures or masking real failures by artificially inflating or deflating PER measurements. Also, removing the box and going radiated introduces path loss variability that is hard to control.

    Best Regards,

    Swathy

Children
Related