Coverage of Array Antenna

Hi there,

I was going through Nordic Semiconductor's Introduction to Bluetooth Direction Finding video. In one slide of that, host talks about area of coverage of Antenna Array. But I am not able to understand it fully. Do we have any number for the coverage, like cone angle? Host also says that we observe performance degradation close to plane, noticeable from about 15 degrees. I got close to plane part, but I don't get how does these 15 degrees comes in picture? 

I have IndeiSemic's AoA antenna which looks like following. How can I measure its coverage area, any idea you can share?

Thanks & Regards,

Yuvraj

Parents
  • Hi,

    The presenter is talking about the elevation angle of the target, relatively to the antenna array, not a distance. When the target is right in front of the array (i.e. on a line that is perpendicular to the plane), the elevation is 90 degrees. When the target is on the plane of the array, the elevation is 0 degrees. Keep in mind, "plane" means an infinite surface that is the extension of the antenna array.

    So what the presenter is saying that the performance degrades below 15 degrees of elevation, which leaves a conical area with a 150 degrees apex angle. You can see it on this sketch below (side-view cross-section):

    This only applies to the side of the array which has the antenna patches on it. On the other (back) side, there is no coverage, as the antenna only* radiate towards the front, and cannot locate a tag behind the antenna array.

    *The antennas do radiate a bit in the backward direction, but this is not intended and the phase is not defined well.

Reply
  • Hi,

    The presenter is talking about the elevation angle of the target, relatively to the antenna array, not a distance. When the target is right in front of the array (i.e. on a line that is perpendicular to the plane), the elevation is 90 degrees. When the target is on the plane of the array, the elevation is 0 degrees. Keep in mind, "plane" means an infinite surface that is the extension of the antenna array.

    So what the presenter is saying that the performance degrades below 15 degrees of elevation, which leaves a conical area with a 150 degrees apex angle. You can see it on this sketch below (side-view cross-section):

    This only applies to the side of the array which has the antenna patches on it. On the other (back) side, there is no coverage, as the antenna only* radiate towards the front, and cannot locate a tag behind the antenna array.

    *The antennas do radiate a bit in the backward direction, but this is not intended and the phase is not defined well.

Children
No Data
Related