How to synchronize PWM with external event

[codezork]

As for dimmer applications neccessary, a pwm signal with variable duty-cycle must be generated to drive a triac. But to be synchronized with the mains' zero crossing, the pwm cycle must be started by a GPIO event from a zero-crossing sensor (optocoupler). What would be the best approach to solve this problem? Has anybody done a similar thing before?

[RK]

I've done exactly this and went through quite a few iterations to get something which worked reliably.

First thing - if you want to use full half-cycles - using a triac with a zero cross turn-on circuit saves a lot of problems. You have plenty of time during one cycle to work out whether you want to turn on for the next one, you don't have to try and get the GPIO on event dead right. Doing this gives you very accurate power with the caveat that you are limited to a resolution of 2x mains frequency. I wish I'd started there because that's actually more than the resolution I needed for my application.

Secondly, if you want to get an event trigger close to the actual zero cross you need a sensor which produces an on pulse fairly towards the start of the cycle and importantly produces a fast-rising one, else the GPIO line bounces. I use one PPI to turn off the GPIOTE as soon as the pulse is registered to stop any bouncing at all, it's turned on again during an interrupt service routine before the next one. For me, an FOD817 (C or D) with about 150k current limiting resistors on the mains side and a 100k pullup on the nRF side gives a good pulse with at least 48% duty cycle. That's for 240v and the resistors get warm! Increasing resistance too much made the edges of the pulse too wide, duty cycle fell closer to 40% and the bouncing was horrible.

I found it best to work 1/2 a cycle ahead, setting up everything to be triggered by the next GPIOTE event using PPI during the interrupt service routine from the last one, then letting PPI actually do the job for me later. Obviously turning things off is easier, you just turn it off at any point and the triac will actually shut down at the next zero cross.

[codezork]

I tried it with pwm and while shifting the duty cycle from 1 to 99% to delay the triac firing in order to phase-cut the half-wave. The problem is that the 50Hz from the mains is not as stable as the pwm and I need to restart the pwm from time to time. As the pwm needs a complete cycle to restart, flickering appears at output. Could you share some code with me showing your solution in detail? I would appreciate this very much. I am using the VOL628A, 33K half watt at both 230V inputs to get the zero crossing, no warming so far. Could not see bounces at the GPIO.