Multilink peripheral s110 v7.3.0, SDK v6.1.0 don't start

[paupoix]

Hi community,

I'm using the multi-link peripheral example from SDK v6.1.0 with s110 soft device version 7.3.0., this is cross-compiled with arm-none-eabi-gcc. The both version are compatible as defined in the matrix compatibility. The device is a NRF51822 revision 2 on pca10001 board.

The return value of the function sd_ble_gap_device_name_set is 0x3001 inside the function gap_params_init.

The last time I got this error value it was due to a mismatch between SDK and soft device version but it is not here, do you know where the problem could be?

Thanks

[Susheel Nuguru]

That is because you have either not called sd_ble_enable function or the call for it has failed.

#define NRF_ERROR_STK_BASE_NUM  (0x3000)    ///< STK error base

#define BLE_ERROR_NOT_ENABLED            (NRF_ERROR_STK_BASE_NUM+0x001) /**< @ref sd_ble_enable has not been called. */

[paupoix]

Hi Aryan,

You have right, the code which calls sd_ble_enable is surrounded by S110 preprocessor flag which is not defined in my project (not KEIL project).

Thanks