This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

MasterControlPanel cant find device

Hi !

I'm trying to run the BLE bootloader example (here). I succesfully programmed the SoftDevice and the DFU bootloader :

image description

The device start in bootloader mode (LED 1 and 3 ON). Then I connect my computer to the device DfuTarg (LED 1 go OFF and LED 2 ON). But the MasterControlPanel can’t find anything.

MasterControlPanel v3.10.0.14 nRFgo Studio v1.21.1

Parents
  • Yes was using my computer bluetooth's. I tried to flash a second board with the master emulator firmware using MCP as you say. But it's not compatible for nRF52 devices. image description

    As a temporary solution, do you think it's possible to use the MCP for Android in the emulator of Android Studio ?

Reply
  • Yes was using my computer bluetooth's. I tried to flash a second board with the master emulator firmware using MCP as you say. But it's not compatible for nRF52 devices. image description

    As a temporary solution, do you think it's possible to use the MCP for Android in the emulator of Android Studio ?

Children