• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 71 subscribers
  • Views 1723 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 114261
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Internal LDO mode (nrf51822) with 3V battery, can I operate till 1.8V Battery voltage ?

Anil_Anehas

Hi,

I am using 2 x AA batteries which gives 3V. Planning to enable all the internal LDOs (1.2V, 1.8V and Radio LDO).

VDD and AVDD are shorted on Board.

Will the device be fully functional till Battery discharges till 1.8V ?

My concern is when VDD is 1.8V, 1.7V LDO and Radio LDO might not give desired outputs ? Is this OK ?

Thanks in advance for the help.

Regards, Anil

Parents
  • 0

    You can operate the device in LDO mode down to 1.8V, see Product Specification chapter 7. Brown-out reset will happen at 1.7V, but you should not go below 1.8V as there may be unpredictable behavior. Battery voltage tend to drop when drawing a lot of current, make sure that the voltage does not go under 1.8V during radio operations.

Reply
  • 0

    You can operate the device in LDO mode down to 1.8V, see Product Specification chapter 7. Brown-out reset will happen at 1.7V, but you should not go below 1.8V as there may be unpredictable behavior. Battery voltage tend to drop when drawing a lot of current, make sure that the voltage does not go under 1.8V during radio operations.

Children
Related
Terms of service