This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DFU using UART

Hi. PCA10028, SDK10.0.0, S130. I'm testing DFU using UART not BLE.

  1. How can i edit UART Tx,Rx pin number?

  2. When I download "dfu_dual_bank_ble_s130_pca10028.hex" using nRFgo Studio, LED1,3 is always ON, whether I push button4 or not during power on. I think LED3 ON means that it starts DFU. So if i don't push button4 during power on, LED3 never on. Can you explain this mode? I need your help.

Parents Reply Children
No Data
Related