This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

External supply of 1.85V

Hello,

If I supply 1.85V on the "External supply" pins, can i use all the modules of the board (nRF51DK)?

I need to have less than 2V on some of the pins as an output, that's why I'm trying to supply the board with the lowest voltage i can. But it's not working, I tried the blinky project and it didn't work.

Thanks for the help,

Jorge Costa

Parents
  • Hi

    There are a couple of things that might be wrong.

    1. The current from the External supply pins goes through a reverse voltage protection diode: image description

    The diode has a typical forward voltage drop of ~0.32V. So if you hook 1.85V to the external pins the voltage fed to the VDD pins on the NRF51 will be closer to 1.55V. You should measure the voltage on the VDD pins and adjust your power supply to accommodate for the voltage drop. Or you can put a solder drop on solder bridge SB12. Note that if you do this you might break your chip if you accidentally reverse the voltage on the input pins.

    1. The LEDs used on the PCA10028 are EL19-21SYGCs. They have a typical forward voltage drop of 2V. Hence if you only supply 1.85V on the GPIO pins they won't light up.

    Refer to the nRF51 DK reference files here.

  • I tried a BLE connection, UART and SPI, and they all work for now. The buttons also work. thank you for the help

Reply Children
No Data
Related