My English is still poor, but I hope you can understand me.
Press the button to call ble_advertising_start(), which may occasionally restart main. I set a short timeout. After the timeout, press the button. What's the problem? The code is below.
#define APP_ADV_TIMEOUT_IN_SECONDS 5
#define GPIO_BT BSP_BUTTON_1
void in_pin_handler(nrf_drv_gpiote_pin_t pin, nrf_gpiote_polarity_t action)
{
uint32_t err_code;
printf("push\n");
nrf_delay_ms(8500);
err_code = ble_advertising_start(BLE_ADV_MODE_FAST);
APP_ERROR_CHECK(err_code);
}
void gpio_input_init(void)
{
ret_code_t err_code;
err_code = nrf_drv_gpiote_init();
APP_ERROR_CHECK(err_code);
nrf_drv_gpiote_in_config_t in_config = GPIOTE_CONFIG_IN_SENSE_HITOLO(true);
in_config.pull = NRF_GPIO_PIN_PULLUP;
err_code = nrf_drv_gpiote_in_init(GPIO_BT, &in_config, in_pin_handler);
APP_ERROR_CHECK(err_code);
nrf_drv_gpiote_in_event_enable(GPIO_BT, true);
}
int main(void)
{
uint32_t err_code;
bool erase_bonds;
// Initialize.
APP_TIMER_INIT(APP_TIMER_PRESCALER, APP_TIMER_OP_QUEUE_SIZE, false);
uart_init();
gpio_input_init();
//buttons_leds_init(&erase_bonds);
ble_stack_init();
gap_params_init();
services_init();
advertising_init();
conn_params_init();
printf("\r\nUART Start!\r\n");
//err_code = ble_advertising_start(BLE_ADV_MODE_FAST);
//APP_ERROR_CHECK(err_code);
// Enter main loop.
for (;;)
{
power_manage();
}
}
