Load code to nrf51422 using nrf51 Dk

[Manu]

Hi,

I need to load ble code to mrf51422. I read on the forum that I can do it using nrf51 dk but did not get the steps. Couod someone give me detailed description about it.

[Jui-Chou (Rick) Chung]

Hello Manu,

You can check the chapter 5.10 "Debug output" in the "nRF51-DK User Guide" in here .

As the document mentioned, if you have the standard 10pin JTAG connector on your target, you can use P19 connector and the pin description shown in Table. 6. Otherwise, you can also use the P20 which the pin description shown in Table. 7.

[Jui-Chou (Rick) Chung]

Hello, no need to use nRFgo to upload the softdevice. Keil can do it too : )